BluPAD Dual LED Blue/White Light Transilluminator

With the 470nm LED light as the excitation light source, the Blue Light mode is applied for observing the qualitative and quantitative nucleic acid or protein experiments using the fluorescent staining

reagents. 

Other than being compatible with our safe reagents, such as the Novel Juice, Novel Green, Novel Green Plus, OnePCR series, Nimble Juice, and Nimble Juice R-TYPE, it also performs well with a majority of fluorescent staining products on the market, such as SYBR Gold, SYBR Green I & II, SYPRO Ruby, SYPRO Orange, and Coomassie Fluor Orange stains, GelStar, GelGreen.

The feature of allowing light intensity adjustment at three different levels enables the user to make the light intensity contrast adjustment based on the sample concentration for achieving the best imaging quality. Further, the magnetic amber filter, with the hinges-free design, offers simplicity, safety, and convenience when opening and closing the filter.

By using the whole-wavelength white LED light as the excitation light source, the White Light mode exhibits softness and uniformity and is applicable for observing or imaging the SDS-PAGE gels that are stained with the Coomassie Blue or Silver Stain.

It can also be employed as a simple film-viewing transilluminator for checking the X-Ray film for the research or clinical purpose. With the light intensity adjustment function, the contrasting adjustment of the light intensity is enabled at three levels according to the observational requirements for achieving the best imaging quality. 

Unit Dimensions ( W*L*H ): 18.5 * 22 * 3 cm

Gel Viewing Dimensions ( W*L): 12 * 18 cm

Input Voltage: 100 - 240 Vac

Input Current: 2.0 A

LED Source: Built-in blue light & white light LED module

LED life ( hours ): >30,000

Emission maxima ( nm ): 470 nm

Store temperature: 25℃

Automatic Power-Off: 5 mins

Filter Type: Amber filter (580nm)

Certifications: CE/ETL

Q :What should I do when unable to observe the sample under the Blue Light Mode?
A: Please confirm the selected light source is the blue light, NOT the WHITE light.

Q: Am I able to visualize the gels stained with ethidium bromide (EtBr)?
A: Ethidium bromide-stained gels can be visualized with the BluPAD transilluminator as ethidium bromide has a smaller secondary excitation peak within the range of 400-570 nm. However, keep in mind that the fluorescence intensity will not be as bright as when excited at the primary excitation peak of 300 nm (Please note the intensity would be lower than when excited at 300 nm.), which would be possible with UV transilluminators.

Q :Bands are not clear, so what should I do?
A :Please ensure the sample’s concentration is sufficient, then you can adjust the brightness to obtain a higher observation quality.

Q :Do the protective films on the white plate/blue tempered glass filter need to be removed before conducting the experiment?
A: Yes, please remove all protective material on white and blue uniform plates.

Q: If any of the accessories is defective, can it be purchased as optional?
A :Yes, please contact your local distributor.

Q: Am I able to disable the automatic power-off function?
A : Unfortunately, it is already embedded for protecting machine, however, the BluPad can be instantly turned on.